Dr-power Chipper User Manual download pdf (Page 13)

7. Position the Belt onto the Field and Brush Mower Pulley (Figure 24) and

then route it over the two Idler Pulleys and up around the Chipper Pulley

(Figure 25).

NOTE: Ensure that the “V” portion of the Belt rests properly into the Idler Pulleys.

8. Move the Belt Release Lever to the “Tighten” position.

NOTE: There is a slot in each of the bottom Tabs of the Belt Guard. These slots

must slide over the Carriage Bolt Guides that are mounted to the inner Frame

Supports of the Chipper (Figure 20 on previous page).

9. Reinstall the Belt Guard and secure with the Hand Knob.

10. Connect the Wire Harness Connector from the Field and Brush Mower to

the Connector of the Chipper Attachment (Figure 26).

Adjusting the Exhaust Deflector on machines with a Briggs and

Stratton 12.5 hp Engine (serial numbers from ATM123741 to

ATM126369).

Tool Needed:

 1/4" Wrench

1. Remove the three Screws that secure the Exhaust Deflector using a 1/4"

Wrench (Figure 27).

2. Rotate the Exhaust deflector so it is facing forward (3 o’clock) and secure in

this position with the three Screws using a 10mm Wrench.

Belt

Figure 24

Chipper Idler

Pulleys

Field and

Brush Mower

Pulle

Twist Belt to

Engage “V”

Properly into

Idler Pulle

Chipper

Connector

rom

Relay

Figure 26

Belt

Figure 25

Idler Pulleys

Chipper

Sprocke

Twist Belt so “V”

Engages Properly into

Chipper Sprocket

Carriage

Bolt for

belt guard

mounting

(one on

each side)

Before performing this Engine change, stop the engine, wait five (5) minutes

to allow all parts to cool. Disconnect the spark plug wires, keeping them away

from the spark plugs.

Screws

Figure 27

Deflector

Point

Forward

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Comments to this Manuals

No comments

Dr-power Chipper User Manual Page 13

Comments to this Manuals

Related products and manuals for Gardening equipment Dr-power Chipper